F6 indicates an error occurred while setting a standard slave, such as attempting to write an A/B slave address like 01A or 01B to a standard slave. The manual lists no action for this code.
- Model
- Fuji Electric TWIN series
- Display shows
- F6
- Type
- Error code
- Source
- Manual p. 15
What F6 means
An error occurred in a standard slave setting. (An attempt was made to write an A/B slave address, e.g., 01A or 01B, to a standard slave.) p. 15
Common causes
- An error occurred in a standard slave setting. (An attempt was made to write an A/B slave address, e.g., 01A or 01B, to a standard slave.) p. 15
If F6 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Fuji Electric service.
This page summarises what the manufacturer’s manual says about F6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Fuji Electric. Found a mistake? Report an error.