Endress+Hauser FMI51, FMI52 Error W 1806: Current output is in simulation mode

Capacitive level transmitter · taken from the manufacturer’s manual, pages cited

Fault codeW 1806

Current output is currently in simulation mode. The manual's first action is: “Set current output to normal mode”

Model
Endress+Hauser FMI51, FMI52
Display shows
Current output is in simulation mode (W 1806)
Type
Fault code
Source
Manual p. 86

What W 1806 means

Current output is in simulation mode p. 86

Common causes

  • Current output is in simulation mode p. 86

What to do

  1. Set current output to normal mode p. 86

If W 1806 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Endress+Hauser service.

Open the manual at page 86 All FMI51, FMI52 error codes Manual details & download

This page summarises what the manufacturer’s manual says about W 1806; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Endress+Hauser. Found a mistake? Report an error.