Endress+Hauser FMI51, FMI52 Error W 1802: Simulation switched on

Capacitive level transmitter · taken from the manufacturer’s manual, pages cited

Fault codeW 1802

Simulation mode is active on the device. The manual's first action is: “Switch off simulation”

Model
Endress+Hauser FMI51, FMI52
Display shows
Simulation switched on (W 1802)
Type
Fault code
Source
Manual p. 86

What W 1802 means

Simulation switched on p. 86

Common causes

  • Simulation switched on p. 86

What to do

  1. Switch off simulation p. 86

If W 1802 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Endress+Hauser service.

Open the manual at page 86 All FMI51, FMI52 error codes Manual details & download

This page summarises what the manufacturer’s manual says about W 1802; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Endress+Hauser. Found a mistake? Report an error.