Emotron VSU Error Codes

39 codes from pages 119–274 of the manual

This is the list of fault, error codes the Emotron manual gives for the VSU Emotron VSU drive. Find your code below and open it for what the manual says about its causes and what to do.

Fault codes from p. 119

CodeWhat it meansPage
U1-00 Code of the latest fault p. 119
1 oC1 p. 249
2 oC2 p. 249
13 ISF p. 253
14 oPL p. 253
15 oL3 p. 253
16 oH1 p. 253
17 oH2 p. 253
18 oH3 p. 254
20 EC1 p. 254
22 dLC p. 254
23 TEr p. 254
24 PEr p. 254
26 to2 p. 254
27 to3 p. 254
28 SUE p. 254
29 EPr p. 254
30 CCL p. 254
31 TrC p. 255
32 PdC p. 255
33 CPy p. 255
35 SFt p. 255
36 CPU p. 255
37 oCr p. 255
38 SP1 p. 255
39 SP2 p. 256
40 AIP p. 256
41 LoU p. 256
45 Plo p. 256

Error codes from p. 274

CodeWhat it meansPage
0x1 Illegal parameter p. 274
0x2 Illegal register address p. 274
0x3 Data error, i.e. data are out of upper limit or lower limit p. 274
0x4 Slave operation failed, including errors caused by invalid data although there are in the range p. 274
0x5 Command is valid and being processed, mainly used for storing data to non-volatile storage p. 274
0x6 Slave is busy, please try again later; mainly used for storing data into non-volatile storage p. 274
0x18 Message frame error: including message length error and check error p. 274
0x20 Parameter is not changeable p. 274
0x21 Parameter is not changeable during the running p. 274
0x22 Parameter is under password protection p. 274

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with Emotron. Found a mistake? Report an error.