Error code65024
The command type or slave address did not match the request, likely indicating another unit is involved. The manual lists no action for this code.
- Model
- ELPRO 415U
- Display shows
- Invalid Responsefrom Slave (65024)
- Type
- Error code
- Source
- Manual p. 79
What 65024 means
Invalid Responsefrom Slave p. 79
Common causes
- Command type or slave address did not match request (probably another unit). p. 79
Safety warnings — read before you start
- WARNINGIncorrect Termination of Supply Wires. INCORRECT TERMINATION OF SUPPLY WIRES MAY CAUSE INTERNAL DAMAGE AND WILL VOID THE WARRANTY. p. 2
- WARNINGRF Exposure Safety. DO NOT OPERATE THE TRANSMITTER WHEN ANYONE IS WITHIN 20 CM OF THE ANTENNA. p. 2
- CAUTIONRF Connector Security. Avoid Operating the transmitter unless all RF connectors are secure and any open connectors are properly terminated. p. 2
- CAUTIONExplosive Atmosphere Safety. Avoid operating the equipment near electrical blasting caps or in an explosive atmosphere. p. 2
If 65024 is still not resolved
- All equipment should be serviced only by a qualified technician. p. 2 “All equipment should be serviced only by a qualified technician.”
This page summarises what the manufacturer’s manual says about 65024; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with ELPRO. Found a mistake? Report an error.