CLRWTR GT Series Error **1027: Remote mode error

Water purifier · taken from the manufacturer’s manual, pages cited

Error code**1027

Remote mode error because the PLC (FP2/FP2SH) is set to RUN mode instead of REMOTE or PROG. mode. The manual's first action is: “Change to the REMOTE mode or PROG. mode.”

Model
CLRWTR GT Series
Display shows
Remote mode error (**1027)
Type
Error code
Source
Manual p. 119

What **1027 means

Remote mode error p. 119

Common causes

  • The PLC (FP2/FP2SH) is set to the RUN mode. p. 119

What to do

  1. Change to the REMOTE mode or PROG. mode. p. 119

Before you service the product, read the safety instructions in the manual p. 2.

If **1027 is still not resolved

  • contact service / dealer p. 2
    “Do NOT USE THE PROGRAMMABLE DISPLAY TO CONTROL SAFETY FEATURES OR OTHER CRITICAL OPERATIONS OF EQUIPMENT OR SYSTEMS.”
  • contact service / dealer p. 2
    “A COMMUNICATION ERROR (FOR ANY REASON) MIGHT PREVENT SUCH SAFETY FEATURES OR CRITICAL OPERATIONS FROM FUNCTIONING PROPERLY.”

This page summarises what the manufacturer’s manual says about **1027; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with CLRWTR. Found a mistake? Report an error.