Error code3
There are not enough data points available for the required calculation. The manual lists no action for this code.
- Model
- Canberra 9233653E V3.0
- Display shows
- 3
- Type
- Error code
- Source
- Manual p. 383
What 3 means
Too few points for the calculation. p. 383
Common causes
- Too few points for the calculation. p. 383
- Not enough points were available to perform the specified calculation (for example, a third order energy calibration requires four data points). p. 383
If 3 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about 3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.