Canberra 9233653E V3.0 Error #256: AN EFFICIENCY CALIBRATION CALCULATION (ECC) PROCESS IS ALREADY RUNNING.

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code#256

AN EFFICIENCY CALIBRATION CALCULATION (ECC) PROCESS IS ALREADY RUNNING. The manual's first action is: “WAIT FOR ITS TERMINATION BEFORE LAUNCHING ANOTHER ECC PROCESS.”

Model
Canberra 9233653E V3.0
Display shows
#256
Type
Error code
Source
Manual p. 408

What #256 means

AN EFFICIENCY CALIBRATION CALCULATION (ECC) PROCESS IS ALREADY RUNNING. p. 408

Common causes

  • You try to launch the Efficiency Calibration Calculation [ECC] process before the previously launched ECC has completed. p. 408

What to do

  1. WAIT FOR ITS TERMINATION BEFORE LAUNCHING ANOTHER ECC PROCESS. p. 408

Before you service the product, read the safety instructions in the manual p. 526.

If #256 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 408 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about #256; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.