Canberra 9233653E V3.0 Error 1310: TOO LONG PARAMETER IN THE INPUT ECC LINE. THE INVALID PARAMETER IS SHOWN ON THE FOLLOWING LINE

Genie™ 2000 Spectroscopy Software · taken from the manufacturer’s manual, pages cited

Error code1310

TOO LONG PARAMETER IN THE INPUT ECC LINE. THE INVALID PARAMETER IS SHOWN ON THE FOLLOWING LINE because a parameter in the .ECC input line exceeds allowed length, such as detector or template names. The manual lists no action for this code.

Model
Canberra 9233653E V3.0
Display shows
1310
Type
Error code
Source
Manual p. 448

What 1310 means

TOO LONG PARAMETER IN THE INPUT ECC LINE. THE INVALID PARAMETER IS SHOWN ON THE FOLLOWING LINE p. 448

Common causes

  • The message is generated while reading input .ECC files. The program found that the argument is too long. The argument is detector name, template name, filename, geometry name. p. 448

If 1310 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.

Open the manual at page 448 All 9233653E V3.0 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 1310; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.