Bus error due to an illegal START or STOP condition occurs when the hardware detects an invalid start or stop signal on the bus. The manual's first action is: “Only the internal hardware is affected, no STOP condition is sent on the bus. In all cases, the bus is released and TWSTO is cleared.”
- Model
- Atmel ATmega640/1280/1281/2560/2561
- Display shows
- Bus error due to an illegal START or STOP condition (0x00)
- Type
- Error code
- Source
- Manual p. 258
What 0x00 means
Bus error due to an illegal START or STOP condition p. 258
Common causes
- Bus error due to an illegal START or STOP condition p. 258
What to do
- Only the internal hardware is affected, no STOP condition is sent on the bus. In all cases, the bus is released and TWSTO is cleared. p. 258
If 0x00 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Atmel service.
This page summarises what the manufacturer’s manual says about 0x00; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Atmel. Found a mistake? Report an error.