G-Switch loop between pins 5 and 12 is not present The manual's first action is: “Verify D-Sub connector jumper is installed by checking for less than 1Ω between pins 5 and 12. Repair as necessary. NOTE: When the installed jumper is removed, wait at least 60+ seconds before a test is done to get a G-switch 'open' on the Self-Test (6 flash error)”
- Model
- ARTEX ELT 1000
- Display shows
- G-Switch loop between pins 5 and 12 is not present (6)
- Type
- Error code
- Source
- Manual p. 32
What 6 means
G-Switch loop between pins 5 and 12 is not present p. 32
Common causes
What to do
- Verify D-Sub connector jumper is installed by checking for less than 1Ω between pins 5 and 12. Repair as necessary. NOTE: When the installed jumper is removed, wait at least 60+ seconds before a test is done to get a G-switch 'open' on the Self-Test (6 flash error) p. 32
- Install G-SW enable jumper between pins 5 and 12 in D-Sub harness connector. p. 32
If 6 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact ARTEX service.
This page summarises what the manufacturer’s manual says about 6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with ARTEX. Found a mistake? Report an error.