ARTEX ELT 1000 Error Codes

7 codes from page 32 of the manual

This is the list of error codes the ARTEX manual gives for the ELT 1000 Emergency Locator Transmitter. Find your code below and open it for what the manual says about its causes and what to do.

Error codes from p. 32

CodeWhat it meansPage
1 System OK p. 32
2 Code not used in the ELT 1000 p. 32
3 Code not used in the ELT 1000 p. 32
4 Low output power p. 32
5 No position data present (long message protocol only. Error is suppressed for short messages) p. 32
6 G-Switch loop between pins 5 and 12 is not present p. 32
7 Battery Check p. 32

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with ARTEX. Found a mistake? Report an error.