Tank pressure is not increasing after the ECU turns the Compressor(s) ON. The manual's first action is: “•Verify Compressor circuit wiring connections. •Check Compressor fuse F2. •Verify Compressor plumbing connections. •Check for Compressor relay failure. •Check for Compressor failure. •Check for Pressure Sensor failure.”
- Model
- AccuAir TouchPad™ Controller
- Display shows
- 2
- Type
- Warning code
- Source
- Manual p. 20
What 2 means
Tank pressure is not increasing after the ECU turns the Compressor(s) ON. p. 20
Common causes
- Tank pressure is not increasing after the ECU turns the Compressor(s) ON. p. 20
What to do
- •Verify Compressor circuit wiring connections. •Check Compressor fuse F2. •Verify Compressor plumbing connections. •Check for Compressor relay failure. •Check for Compressor failure. •Check for Pressure Sensor failure. p. 20
Before you service the product, read the safety instructions in the manual p. 4.
If 2 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact AccuAir service.
This page summarises what the manufacturer’s manual says about 2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with AccuAir. Found a mistake? Report an error.