ABB ACS550-01 / ACS550-U1 Error 3107: AR AI

ACS550-01/U1 drive · taken from the manufacturer’s manual, pages cited

Fault code3107

Automatic Reset for Analog Input Below Minimum is enabled or disabled, determining whether the drive will reset and resume operation after detecting a value below the minimum threshold. The manual's first action is: “• 0 = DISABLE – Disables automatic reset. • 1 = ENABLE – Enables automatic reset. • Automatically resets the fault (AI

Model
ABB ACS550-01 / ACS550-U1
Display shows
AR AI
Type
Fault code
Source
Manual p. 152

What 3107 means

AR AIp. 152

Common causes

  • Sets the automatic reset for the analog input less than minimum value function on or off. p. 152

What to do

  1. • 0 = DISABLE – Disables automatic reset. • 1 = ENABLE – Enables automatic reset. • Automatically resets the fault (AI p. 152

Before you service the product, read the safety instructions in the manual p. 6.

If 3107 is still not resolved

  • contact your local ABB representative for replacement p. 6
    “Never attempt to repair a malfunctioning drive; contact your local ABB representative for replacement.”
  • For more technical information, contact your local ABB representative. p. 7
    “For more technical information, contact your local ABB representative.”
Open the manual at page 152 All ACS550-01 / ACS550-U1 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 3107; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with ABB. Found a mistake? Report an error.