ABB ACH550 Error 3013: DRIVE 1ST START

AC drive · taken from the manufacturer’s manual, pages cited

Fault code3013

DRIVE 1ST START indicates the drive has started but bypass mode cannot be entered yet. The manual's first action is: “Run bypass unit in drive mode before attempting bypass mode”

Model
ABB ACH550
Display shows
DRIVE 1ST START (3013)
Type
Fault code
Source
Manual p. 68

What 3013 means

DRIVE 1ST START p. 68

Common causes

What to do

  1. Run bypass unit in drive mode before attempting bypass mode p. 68

Before you service the product, read the safety instructions in the manual p. 2.

If 3013 is still not resolved

  • contact the factory or your local Authorized Service Center for repair or replacement. p. 2
    “Never attempt to repair a malfunctioning ACH550; contact the factory or your local Authorized Service Center for repair or replacement.”
Open the manual at page 68 All ACH550 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 3013; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with ABB. Found a mistake? Report an error.