Industrial

This document provides specifications for the SMT Power Inductors - Series MSS1038 by Coilcraft, Inc. in 2005. It includes information on the packaging, inductance value, DC resistance, self-resonant frequency, maximum saturation current, and operating temperature range of the inductors.

This document introduces Huawei's smartphone products, including the P series, Mate series, and Nova series. Each series contains multiple models. The latest model in the P series is the P50, the latest model in the Mate series is the Mate X2, and the latest model in the Nova series is the Nova 9.

MVCA1Z, MVCA2Z SD Card Host IP is a hardware IP that implements the CPRM (Content Protection for Recordable Media*) function with an SD host device.

This is a data sheet for a small signal transistor, model MPS4123/D, which is a NPN silicon transistor. Its maximum collector-emitter voltage is 30V, maximum collector-base voltage is 40V, maximum emitter-base voltage is 5.0V, maximum collector current is 200mA, and total power dissipation is 625mW. Its operating and storage temperature range is -55°C to +150°C.

The MN63121 is a 1K-bit EEPROM supporting serial I/O and operating on a single power supply with a volt- age between 1.8 and 5.5 V. It provides the following pins for easy interfacing to microprocessors or microcontrollers: chip select (CS), serial clock (SCK), data input (DI), data output (DO), reset (RESET), and busy (RDY/BUSY). It includes a built-in timer for use in automatically erasing and writing data during data up- date operations. The memory organization is 64 × 16 bits. The chip in- dicates the end of a write operation with either the RDY/ BUSY pin or the state of the DO pin after the status out- put mode has been set. Conversion of peripheral circuits to CMOS realizes great reductions in power consumption. Use of floating gate memory cells and a built-in error correction circuit ensures reliable operation for 105 write cycles.

The document introduces the MMSZ5221ET1 series preferred device Zener voltage regulators 500 mW SOD−123 surface mount

The MM5486 is a National Semiconductor LED display driver that uses N-channel metal gate low-threshold enhancement mode and ion-implanted depletion mode devices. It is available in a 40-pin molded dual-in-line package. The MM5486 is designed to drive common anode-separate cathode LED displays. A single pin controls the LED display brightness by setting a reference current through a variable resistor connected to VDD.

MK1418/MK1420 OPL3, OPL4+Codec Clock Source is a type of audio clock generator produced by MicroClock Division of ICS company. This clock generator can provide clock signals for Analog Devices' AD1848, Crystal Semiconductor's CS4231, Yamaha's OPL3L, OPL3LS and OPL4 audio codec. It can use a 14.318MHz crystal or a 14.318MHz bus clock input to generate the required codec clocks and the 33.868MHz required for the FM or wavetable music synthesizer. This clock generator is packaged in an 8-pin SOIC and can save component count, board space and cost over surface mount crystals, and increase reliability by eliminating three or four mechanical devices from the board.

This document introduces the features of MIC5209, including low dropout voltage, low static current, reverse battery protection, current limiting, overtemperature shutdown, etc.

The MIC5206 is an efficient linear voltage regulator with very low dropout voltage (typically 17mV at light loads and 165mV at 150mA), and very low ground current (600µA at 100mA output), with better than 1% initial accuracy. It has a logic compatible enable/shutdown control input and an internal undervoltage monitor. Designed especially for hand-held, battery-powered devices, the MIC5206 can be switched by a CMOS or TTL compatible logic signal. When disabled, power consumption drops nearly to zero. Dropout ground current is minimized to prolong battery life. Key features include an undervoltage monitor with an error flag output, a reference bypass pin to improve its already low- noise performance (8-lead versions only), reversed-battery protection, current limiting, and overtemperature shutdown. The MIC5206 is available in several fixed voltages in a tiny SOT-23-5 package. It features a pinout, similar to the LP2980, but has significantly better performance. Fixed and adjustable output voltage versions, featuring the reference bypass option, are available in the 8-lead Micrel Mini 8™ 8-lead MSOP (micro small-outline package). For low-dropout regulators that are stable with ceramic output capacitors, see the µCap MIC5245/6/7 family.

MH8S64DBKG is a 8388608-word by 64-bit Synchronous DRAM module. It consists of eight industry standard 4Mx16 Synchronous DRAMs in TSOP and one industry standard EEPROM in TSSOP. The module is suitable for applications where high densities and large quantities of memory are required. It is a socket type memory module, suitable for easy interchange or addition of modules.

This datasheet provides the specifications of MF-MSMF series fuses, including rated current, rated voltage, maximum current, maximum resistance, holding current, breaking current, breaking time, power consumption, operating temperature and so on.

ECM Electronics Limited provides ECM axial molded chokes with high temperature tolerance, high solvent resistance and low EMI.