Industrial

The TS94x series is a family of micropower operational amplifiers characterized for 2.5 V to 10 V operation over a -40° C to +85° C temperature range. They exhibit excellent consumption -1.2 µA, while featuring 10 kHz gain bandwidth product, 1.5 mA output capability and output rail-to-rail operation - 2.85 V typical at 3 V with RL=10 kΩ.

The TS613 is a dual operational amplifier featuring a high output current, large gain-bandwidth product, and the ability to drive a 25Ω load with a 160mA output current at ±6V power supply. This device is particularly intended for applications where multiple carriers must be amplified simultaneously with very low intermodulation products.

TS93x, TS93xA, TS93xB are low power, single supply, rail to rail output operational amplifiers, suitable for battery powered, portable communication systems, alarms, smoke detectors, instrumentation and sensors, PH meters, digital scales, automotive applications

TS861, TS862, TS864 are rail-to-rail micropower BiCMOS comparators from Renesas, featuring ultra low current consumption, rail to rail CMOS inputs, push pull outputs, supply operation from 2.7 to 10 V, low propagation delay, 2 kV ESD protection and A class latch-up immunity. It is suitable for battery-powered systems, portable communication systems, smoke/gas/fire detectors, portable computers and more.

This document describes the features and characteristics of the TS321 low-power single operational amplifier, including large output voltage swing, low supply current, low input bias current, low input offset voltage, etc.

This document introduces the features and applications of TS97x series operational amplifiers. The series of operational amplifiers operates with voltages as low as ±1.35 V and features output rail-to-rail signal swing. The TS97x are particularly well suited for portable and battery-supplied equipment. Very low noise and low distortion characteristics make them ideal for audio pre-amplification.

The TS461, TS462 and TS464 are a family of operational amplifiers from STMicroelectronics that are designed for use in portable and battery-supplied equipment. They offer excellent output rail-to-rail performances at an attractive cost.

TS951, TS952, TS954 are low-power operational amplifiers from ST. They are packaged in SOT23 and feature high conversion rate, low power consumption and wide voltage range. They can be applied to various portable devices.

The TS921 is a rail-to-rail single operational amplifier with features including low noise, low distortion, high output current, etc. It is suitable for low voltage audio systems, mobile phones, etc.

The UA741 is a monolithic operational amplifier produced by ST. It features a large input voltage range, no latch-up, high gain, short circuit protection, no frequency compensation required, and is pin compatible with the UA709.

The TS522 is a monolithic dual operational amplifier mainly dedicated to audio applications. It offers a very low input offset voltage as well as low voltage noise (4.5 nV/√Hz) and high dynamic performances (15 MHz gain bandwidth product, 7 V/μs slew rate).

The TSH95 is a low-power, high-frequency quad operational amplifier designed for high-quality video processing with 4.5 mA supply current and 150 MHz bandwidth.

The TSH24 is a quad bipolar operational amplifier offering a single supply operation from 3V to 30V with very good performances: medium speed (25MHz), unity gain stability and low noise. The TSH24 is therefore an enhanced replacement of standard dual operational amplifiers.

The TS914 is a rail-to-rail CMOS quad operational amplifier designed to operate with a single or dual supply voltage. It has rail-to-rail input and output voltage ranges, extremely low input bias current of 1 pA (typical), low input offset voltage of 5 mV (maximum, A grade), and is specified for 600 Ω and 100 Ω loads. The supply current is low at 200 μA/amp (VCC = 3V). It also features latch-up immunity.