Industrial

This document introduces the use of Programmable Mixing function, which can automatically compensate for adverse control interactions (such as trim, model inaccuracies, etc.).

M218QAN is a 5x7 mm, 3.3 volt, HCMOS/TTL compatible output, Clock Oscillator produced by MtronPTI.

M24512 is a 512Kbit serial I²C Bus EEPROM from Micron, supports 400kHz protocol, supply voltage range is 1.8V to 5.5V, supports byte and page write, can be read and write, has self-timed programming cycle, automatic address incrementing, enhanced ESD/Latch-Up protection and other characteristics, data retention time exceeds 40 years.

M41T00CAP is a serial access real-time clock (RTC) with integral backup battery and crystal.

M41T66 is a serial real-time clock with alarm function. It has counters for various time units, supports I2C bus, and is suitable for lithium-ion rechargeable devices.

STCD1020, STCD1030, STCD1040 are low-power, low-phase-noise multi-channel clock distribution circuits. They are available in 2, 3 or 4-output versions with single-ended sine or square-wave clock input and output. Each output has an independent clock enable, reducing clock source fanout. The input does not require AC coupling capacitors, making them ideal for multi-mode RF clock references and baseband peripherals clock references.

This is a document about the M41T00AUD product, which is a serial real-time clock (RTC) with audio features. It features a 256 and 512 Hz tone generator, a 300 mW differential audio amplifier with a gain range of -33 to +12 dB, and operates in the temperature range of 0 °C to 70 °C. The RTC is based on M41T00 and offers additional functionalities such as automatic backup switchover circuit, ultra-low backup current, on-chip trickle charge circuit, 400 kHz I2C bus, and calibration register for adjustments.

This datasheet provides details on the M4T28-BR12SH and M4T32-BR12SH, which are SNAPHAT® SOIC-packaged non-volatile TIMEKEEPER® and supervisor devices that provide battery backup power.

The M41T93 is a high-precision, low-power, programmable, anti-interference RTC solution that provides battery switchover function for serial SPI bus real-time clock.

M41T82/M41T83 is a ultra-low power, low cost, programmable real-time clock (RTC) with battery switchover function, support I2C bus, widely used in consumer electronics, industrial, medical, etc.

This document describes the features and characteristics of the M41T81S serial access real-time clock (RTC) with alarms, including counters, 32 KHz crystal oscillator, serial interface, ultra-low battery supply current, etc.

The M41T00S is a serial real-time clock with 2.0 to 5.5 V clock operating voltage, counters for seconds, minutes, hours, day, date, month, year, and century, software clock calibration, automatic switchover and deselect circuitry, low operating current of 300 µA, oscillator stop detection, battery or SuperCap™ backup, -40 to 85 °C operating temperature and ultra-low battery supply current of 0.6 µA.

This document describes the features and functions of M41T62, M41T63, M41T64, and M41T65 serial real-time clock (RTC) products, including 400 kHz I2C serial interface, memory mapped registers, timekeeping current, operating voltage range, low-power mode, programmable square wave output, and programmable alarm.