Industrial

The STBP120 is an overvoltage protection device from STMicroelectronics, which features high voltage N-channel MOSFET switch, low RDS(on), integrated charge pump, soft start, enable input (EN), fault indication output (FLT).

The MB90570/A series is a general-purpose 16-bit microcontroller developed and designed by Fujitsu for process control applications in consumer products that require high-speed real time processing. It contains an I2C bus interface that allows inter-equipment communication to be implemented readily. This product is well adapted to car audio equipment, VTR systems, and other equipment and systems. The instruction set of F2MC-16LX CPU core inherits AT architecture of F2MC family with additional instruction sets for high-level languages, extended addressing mode, enhanced multiplication/division instructions, and enhanced bit manipulation instructions. The microcontroller has a 32-bit accumulator for processing long word data. The MB90570/A series has peripheral resources of an 8/10-bit A/D converter, an 8-bit D/A converter, UART (SCI), an extended I/O serial interface, an 8/16-bit up/down counter/timer, an 8/16-bit PPG timer, I/O timer (a 16-bit free run timer, an input capture (ICU), an output compare (OCU)).

The LD39050 is a 500mA low quiescent current low noise voltage regulator, with an input voltage range from 1.5 to 5.5V. It features ultra low dropout voltage, low quiescent current, and low noise, making it suitable for low power battery-powered applications such as mobile phones, personal digital assistants (PDAs), and cordless phones.

This document describes the features and characteristics of the VIPER15 offline high voltage converter, including 800V avalanche rugged power section, quasi-resonant control, low standby power, adjustable overcurrent protection, adjustable overvoltage protection, soft-start function, etc.

STM6600 and STM6601 are smart push-button on/off controllers with Smart Reset™ and power-on lockout, which are suitable for portable devices, terminals, audio and video players, cell phones and smart phones, PDAs, palmtops, organizers and other electronic devices.

The MB90570 series is a general-purpose 16-bit microcontroller developed and designed by Fujitsu for process control applications in consumer products that require high-speed real time processing.

The MB90570 series is a general-purpose 16-bit microcontroller developed and designed by Fujitsu for process control applications in consumer products that require high-speed real time processing.

L6788A is a 3-phase controller with embedded drivers for the next GPU generation

LNBH23L is an LNB supply and control IC with step-up and I²C interface. It features a built-in DC-DC converter for single 12V supply operation and high efficiency (typical 93% @ 0.5A). The output current limit can be selected by an external resistor. It is compliant with main satellite receivers output voltage specification. The auxiliary modulation input facilitates DiSEqC™ 1.X encoding. It has an accurate built-in 22kHz tone generator that suits widely accepted standards. It also has a low-drop post regulator and high efficiency step-up PWM with integrated power NMOS to allow low power losses. It has overload and over-temperature internal protections with I²C diagnostic bits. It also has LNB short circuit dynamic protection. The output power pins are ±4kV ESD tolerant.

This document describes a continuous (more than 5A pulsed) step-down switching regulator with synchronous rectification. Its features include: 4A output current (more than 5A pulsed), operating input voltage from 2.9V to 18V, external 1.8V ± 2% reference voltage, output voltage from 0.6V to input voltage, MLCC compatible, 200ns TON, programmable UVLO matching 3.3V, 5V and 12V bus, FSW programmable up to 1MHz, voltage feed-forward, zero-load current operation, programmable current limit on both switches, programmable sink current capability, pre-bias start up capability, thermal shutdown, etc.

The MB90560/565 series is a 16-bit microcontroller in the F2MC-16LX family with a multi-function timer that can output a programmable waveform. The series includes high-level language instructions, extended addressing modes, enhanced signed multiplication and division instructions, and a complete range of bit manipulation instructions.

This document describes the features of the L6562AT transition-mode PFC controller released in March 2009, including guaranteed performance for extreme temperature range, proprietary multiplier design for minimum THD, very accurate adjustable output overvoltage protection, ultra-low start-up current, low quiescent current, digital leading-edge blanking on current sense, disable function on E/A input, 1% internal reference voltage, -600/+800 mA totem pole gate driver with active pull-down, and its applications in PFC pre-regulators such as street lighting and IEC61000-3-2 compliant SMPS (Flat TV, monitors, desktop PC, games).

L6599A is an improved high-voltage resonant controller with features including 50% duty cycle, variable frequency control, high-accuracy oscillator, and operating frequency up to 500kHz.

This document describes the functions and operation of the Fujitsu semiconductor MB90560 series 16-bit microcontroller. It is a general-purpose product that can be used for designing application specific integrated circuits (ASICs).