Texas Instruments manuals, page 95
TEXAS INSTRUMENTS UCC28521 handbook
This document introduces UCC28521/28 combination PFC/PWM controllers, which provide complete control functionality for any off-line power system requiring compliance with the IEC1000−3−2 harmonic reduction requirements. By combining the control and drive signals for the PFC and the PWM stages into a single device, significant performance and cost benefits are gained. Based on the UCC28511, the new devices employ an average current mode control architecture with input voltage feedforward. The major difference of the UCC28521/28 is that it uses trailing-edge PFC and trailing-edge PWM modulation, which provides higher switching speed.
TEXAS INSTRUMENTS 54AC16822 54ACT16822 74AC16822 74ACT16822 20-BIT D-TYPE FLIP-FLOPS WITH 3-STATE OUTPUTS handbook
This document describes a 20-bit D-type flip-flop with 3-state outputs. It utilizes the Widebus family technology and features inputs that are compatible with TTL or CMOS voltage levels. It is suitable for high-speed layout and has high immunity to switching noise. The product consists of two 10-bit sections with separate control signals.
TEXAS INSTRUMENTS TMS320C6713 TMS320C6713B FLOATING-POINT DIGITAL SIGNAL PROCESSORS handbook
TMS320C6713 is the highest-performance floating-point digital signal processor (DSP) from Texas Instruments. It has a 32-bit instruction word width, 32/64-bit data width, and clock frequencies of 300-, 225-, 200-MHz (GDP), and 200-, 167-MHz (PYP). The chip features eight 32-bit instructions/cycle, a rich peripheral set, an optimized C/C++ compiler, and an advanced VLIW DSP core.
TEXAS INSTRUMENTS TPS736xx handbook
The TPS736xx is a cap-free, NMOS, 400mA low-dropout regulator with reverse current protection. It uses a new topology that allows stable operation with or without output capacitors, including capacitors with low ESR. The TPS736xx features high reverse blockage, constant ground pin current, and low dropout voltage.
TEXAS INSTRUMENTS TPS73201 TPS73215 TPS73216 TPS73218 TPS73225 TPS73230 TPS73233 TPS73250handbook
TPS732xx series is a NMOS switching type low dropout regulator produced by TI, with a 250mA output current, using SOT223 and SOT23 packages, supports 1.7V to 5.5V input voltage range, has 0.5% initial accuracy and 1% total accuracy, working current as low as 1µA, very suitable for portable applications.
TEXAS INSTRUMENTS SN5410 SN54LS10 handbook
This is a datasheet for SN5410, SN54LS10, SN54S10, SN7410, SN74LS10, SN74S10 triple 3-input positive-NAND gates
TEXAS INSTRUMENTS TP3064A TP3067A TP13064A TP13067A MONOLITHIC SERIAL INTERFACE COMBINED PCM CODEC AND FILTER handbook
The TP3064A, TP3067A, TP13064A, and TP13067A are comprised of a single-chip PCM codec and PCM line filter, which can be used to interface a full-duplex voice telephone circuit with a TDM system. They provide functions including transmit high-pass and low-pass filtering, receive low-pass filter with (sin x)/x correction, µ-Law or A-Law compatible coder and decoder, internal precision voltage reference, serial I/O interface, internal autozero circuitry, etc. They support ±5V operation, have low operating power, and can automatically power down. They have a TTL- or CMOS-compatible digital interface and maximize line interface card circuit density. They are improved versions of National Semiconductor TP3064, TP3067, TP3064-X, and TP3067-X.
TEXAS INSTRUMENTS THS8134 THS8134A THS8134B Manual
The THS8134 is a general-purpose triple high-speed D/A converter (DAC) optimized for use in video/graphics applications. The device operates from a 5-V analog supply and a 3-V to 5-V range digital supply. The THS8134 has a sampling rate up to 80 MSPS. The device consists of three 8-bit D/A converters and additional circuitry for bi-level/tri-level sync and blanking level generation in video applications. THS8134 is also well-suited in applications where multiple well-matched and synchronously operating DACs are needed; for example, I-Q modulation and direct-digital synthesis in communications equipment.
TEXAS INSTRUMENTS SN74LVC1G240 handbook
The SN74LVC1G240 is a single line driver that supports 1.65V to 5.5V VCC operation. This product uses NanoStar and NanoFree package technology, which is a breakthrough in IC packaging concepts.
TEXAS INSTRUMENTS TPS65140/TPS65145 handbook
The TPS65140/145 is a triple output LCD supply with linear regulator and power good. The device has a 2.7-V to 5.8-V input voltage range, 1.6-MHz fixed switching frequency, 3 independent adjustable outputs, a main output up to 15 V with less than 1% typical output voltage accuracy, a negative output voltage down to -12 V/20 mA, a positive output voltage up to 30 V/20 mA, an auxiliary 3.3-V linear regulator controller, internal soft start, internal power-on sequencing, fault detection of all outputs, and thermal shutdown.
TEXAS INSTRUMENTS SN54ABTH16244 SN74ABTH16244 handbook
SN54ABTH16244 and SN74ABTH16244 are 16-bit buffers/drivers with 3-state outputs. They feature state-of-the-art EPIC-ΙΙB BiCMOS design that significantly reduces power dissipation. The latch-up performance exceeds 500 mA per JESD 17. The typical VOLP (Output Ground Bounce) is less than 1 V at VCC = 5 V, TA = 25°C. The distributed VCC and GND pins minimize high-speed switching noise. The flow-through architecture optimizes PCB layout. The devices have high-drive outputs (-32 mA IOH, 64 mA IOL). Bus hold on data inputs eliminates the need for external pullup/pulldown resistors. ESD protection exceeds 2000 V per MIL-STD-883, Method 3015; exceeds 200 V using machine model (C = 200 pF, R = 0). Package options include plastic shrink small-outline (DL), thin shrink small-outline (DGG), thin very small-outline (DGV) packages, and 380-mil fine-pitch ceramic flat (WD) packages.
TEXAS INSTRUMENTS SN74AVCAH164245 handbook
This document describes a 16-bit (dual-octal) noninverting bus transceiver with dynamic drive capability and noise reduction function. The product features a dual-rail design that operates within a power supply range of 1.4V to 3.6V.
TEXAS INSTRUMENTS TPS2140/TPS2141/TPS2150/TPS2151 handbook
The TPS2140/41/50/51 is a USB 1.0 and 2.0 Specification-compatible IC that contains a dual-current-limiting power switch and an adjustable low dropout regulator (LDO). Both the switch and LDO limit inrush current by controlling the turnon slew rate. The unique dual-current-limiting feature of the switch allows USB peripherals to utilize high-value capacitance at the output of the switch, while keeping the inrush current low. During turnon, the switch limits the current delivered to the capacitive load to less than 100 mA. When the output voltage from the switch reaches a threshold, the switch lowers the current-limiting threshold to allow the load's current requirements to be met before the load's voltage stabilizes.
TEXAS INSTRUMENTS SN54ALS157A SN54ALS158 SN74ALS157A SN74ALS158 SN74AS157 SN74AS158
This is a document about quadruple 1-of-2 data selectors/multiplexers, including models SN54ALS157A, SN54ALS158, SN74ALS157A, SN74ALS158, and SN74AS157. These products have buffered inputs and outputs, provide full data selection, and have a separate control input. The document describes the operating temperature range and data output type for each model.
TEXAS INSTRUMENTS GD65232 handbook
The GD65232 and GD75232 are single chips that provide an easy interface between the UART and serial-port connector of IBM PC/AT and compatibles. They meet or exceed the requirements of TIA/EIA-232-F and ITU v.28 standards and support data rates up to 120 kbit/s.