UZY-100S tuning fork level switch is a new level switch. Instrumentation consists of a transmitter and amplifier components fork, fork root compression in two piezoelectric crystals, a group as the driving Actuator driving fork vibration, the other group as a detector for converting the voltage signal into the prongs. When the prong is blocked, the amplitude of the vibrator is small, the vibration frequency is changed, the relay Output switching signal. In order to achieve level limit measurement. Sensors made of 316 stainless steel, corrosion resistant mild for limit controllers and high / low alarm.
The UZY-100S tuning fork level switch is a new type of level switch designed for limit control and high/low level alarms. The instrument consists of a transmitter fork and an amplifier. It uses two groups of piezoelectric crystals at the root of the fork: one acts as a driver to vibrate the fork, and the other acts as a detector to convert the vibration into a voltage signal. When the fork is blocked by a medium, the vibration amplitude decreases and the frequency changes, triggering a relay output switching signal.
| Power Supply | 24VDC (Standard); 220VAC (Optional) |
|---|---|
| Operating Temperature | -20℃～70℃ |
| Output Mode | PNP/NPN Output |
| Medium Temperature | -40℃～85℃ |
| Working Pressure | Less than 2MPa |
| Medium Density | Minimum 0.6g/cm³ |
| Delay Time | 1～60s (Optional) |
| Protection Rating | IP66 |
| Process Connection | NPT 1" Thread (Standard); Flange (Optional) |
The sensor is made of 316 stainless steel, which is resistant to mild corrosion.
Connect the power, insert the switch vertically into water with a depth greater than 25mm (relay closes), then lift it out (relay opens).