Key facts
- Brand
- Nordson
- Model
- C0114
- Documents
- 2
- Languages
- EN · ES
- Last added
- 2026-11-10
Start here

Nordson Encore C0114 LT Manual Powder Spray System Operator Card
This operator card covers the Nordson Encore C0114 LT manual powder spray system, including the controller interface, configuration functions, electrostatic settings (Select Charge, Custom, Classic, and Encore LT PE modes), and powder flow settings (Smart Flow and Classic Flow modes). It also describes system operation, purge and fluidizing air behavior, and controller sleep/wake functions.
The card provides maintenance instructions for cleaning the spray gun nozzle, powder path, pump nozzle, and venturi throat, along with a troubleshooting table addressing common problems such as no powder spray, uneven patterns, low powder flow, poor transfer efficiency, and keypad issues.
Nordson C0114 specifications
| Gun Type Setting | 0 = Encore |
|---|---|
| Fluidizing Setting | 0 = Hopper, 1 = Box, 3 = Disable |
| Electrostatic Control Setting | 0 = Custom, 1 = Classic, 2 = PE |
| Powder Flow Control Setting | 0 = Smart, 1 = Classic |
| Cable Length Setting | 0 = 6 meters, 1 = 12 meters, 2 = 18 meters |
| Vibratory Box Delay | 0−90 seconds (factory default 30) |
| STD kV Range | 0 or 25−100 kV |
| Re-Coat Select Charge Mode | 100 kV, 15 μA |
| Metallics Select Charge Mode | 50 kV, 50 μA |
| Deep Recesses Select Charge Mode | 100 kV, 60 μA |
| Minimum Input Air Pressure | Greater than 4.1 bar (60 psi) |
| Ground Resistance | Less than 1 mΩ |
| Controller Sleep Timeout | Approximately 15 minutes |
Source: Nordson Encore C0114 LT Manual Powder Spray System Operator Card
All Nordson C0114 documents by type
The shortest path to a working setup, usually only a few pages.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
How do I wake the controller from sleep mode?
Press the Enable/Disable button, pull the gun trigger, press the purge switch, or press a button on the controller interface. The system goes to sleep automatically after approximately 15 minutes of no activity.
From: Nordson Encore C0114 LT Manual Powder Spray System Operator Card
How do I enter controller configuration mode?
During power up or wake up from disable, press and hold the + and − buttons on the kV/μA panel for 1 second. The kV/μA panel displays F − 1 for function 1 when configuration mode is active.
From: Nordson Encore C0114 LT Manual Powder Spray System Operator Card
What is the document number of this manual?
The document number is P/N 317 133 G.
From: Nordson Excel 2000/C0114 Powder Application System User Manual
Who manufactures the Excel 2000/C0114 system?
Nordson Corporation manufactures the system.
From: Nordson Excel 2000/C0114 Powder Application System User Manual
