Emtronix ETR232i Manuals

ManualLib has 2 documents for the Emtronix ETR232i (Board): 1 user manual, 1 datasheet. Every file can be read online or downloaded as a PDF for free.

User Manual 1Datasheet 1

Key facts

Model
ETR232i
Category
Board
Industry
Electronics
Documents
2
Languages
ZH
Last added
2026-11-17

Start here

Emtronix ETR232i Embedded Network Module Development Evaluation Board Manual

Emtronix ETR232i Embedded Network Module Development Evaluation Board Manual

User Manual 14 pages · 312 KB · ZH

This manual describes the ETR232i embedded network module development evaluation board from Emtronix. It lists the board's 14 hardware connectors and two jumpers, their locations, and usage. It also applies to the ETR232H module because the development evaluation boards are identical.

The document provides signal definitions for connectors such as CN1 power input, CN2 Ethernet, CN3 COM1 debug port, CN4 COM3 RS232, CN5 COM3 RS485, CN6 and CN7 expansion buses, CN8 COM2, and CN9 LCD, plus jumper settings and an appendix with mechanical dimensions. This manual is written in Chinese.

Read online

Emtronix ETR232i specifications

Module coreR1610C
Module dimensions74 mm x 53 mm
Power input+5 V DC
Ethernet interface10M/100M compatible RJ45
COM13-wire RS232, RS232 level, debug port
COM3 (RS232)3-wire RS232, RS232 level
COM3 (RS485)RS485 bus interface; COM3 selectable RS232/RS485
COM29-wire RS232, TTL/CMOS level
Expansion bus CN620-pin IDC, simplified ISA bus
Expansion bus CN710-pin IDC, high address lines
LCD interface CN920-pin IDC
GPIO interface CN1016-pin IDC, can connect matrix keyboard
SIM card socket CN11SIM card socket for GPRS
MC39i connection CN12ZIF 40-pin socket on board back
Module connection36-pin IDC socket x2
JP12-pin SIP selects debug or run mode
JP23-pin SIP selects COM3 RS232 or RS485
Default RS485 drive modeTX-driven mode
CS1 default address range300h-37Fh
CS0 default address range200h-27Fh; can be set to memory mode

Source: Emtronix ETR232i Embedded Network Module Development Evaluation Board Manual

All Emtronix ETR232i documents by type

User Manual 1

Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.

Datasheet 1

Ratings, dimensions and ordering codes, for selection and design work.

Questions answered in these manuals

What voltage does CN1 require?

CN1 accepts +5 V DC.

From: Emtronix ETR232i Embedded Network Module Development Evaluation Board Manual

How is JP1 used?

Short JP1 for debug mode; leave it open for normal run mode.

From: Emtronix ETR232i Embedded Network Module Development Evaluation Board Manual

What voltage and current does the ETR232i require?

It operates from a 5 V ± 5 % supply and draws about 330 mA.

From: Emtronix ETR232i Embedded Network Module Data Sheet

What are the mechanical dimensions of the ETR232i?

The module measures 74 mm by 53 mm.

From: Emtronix ETR232i Embedded Network Module Data Sheet