Key facts
- Brand
- Dell EMC
- Model
- N-Series (N1100-ON
- Category
- Network Switches
- Documents
- 4
- Languages
- EN
- Last added
- 2023-11-20
Start here

Dell EMC Networking N-Series N1100-ON, N1500, N2000, N2100-ON, N3000, N3000-ON, N3100-ON, and N4000 Switches CLI Reference Guide
This document serves as a comprehensive reference for the Command Line Interface (CLI) of Dell EMC Networking N-Series switches, including models N1100-ON, N1500, N2000, N2100-ON, N3000, N3000-ON, N3100-ON, and N4000. It covers Version 6.5.2.x for N1500/N2000/N2100-ON/N3000/N3000-ON/N3100-ON/N4000 Series and Version 6.4.x.x for N1100-ON Series switches. The guide details regulatory models and provides instructions on using the CLI for network management.
Read onlineDell EMC N-Series (N1100-ON specifications
| Supported Models | N1100-ON, N1500, N2000, N2100-ON, N3000, N3000-ON, N3100-ON, N4000 |
|---|---|
| Software Version | 6.5.2.x (N1500/N2000/N2100-ON/N3000/N3000-ON/N3100-ON/N4000), 6.4.x.x (N1100-ON) |
| Default IPv4 Assignment (N1100/N1500/N2000/N2100-ON) | DHCP on VLAN 1 |
| Default IPv4 Assignment (N3000/N3100/N4000) | none on VLAN 1 |
All Dell EMC N-Series (N1100-ON documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
- Dell EMC Networking N-Series N1100-ON, N1500, N2000, N2100-ON, N3000, N3000-ON, N3100-ON, and N4000 Switches CLI Reference Guide 2000 p
- Dell EMC Networking N-Series N1100-ON, N1500, N2000, N2100-ON, N3000, N3100-ON, and N4000 Switches CLI Reference Guide 2000 p
- Dell EMC Networking N-Series N1100-ON, N1500, N2000, N2100-ON, N3000, N3100-ON, and N4000 Switches CLI Reference Guide 2000 p
- Dell EMC N-Series N1100-ON/N1500/N2000/N2100-ON/N3000/N3100-ON/N4000 Switches User's Configuration Guide 1782 p
Questions answered in these manuals
Which CLI version applies to the N1100-ON series?
The N1100-ON Series Switches use CLI Version 6.4.x.x.
What is the default IPv4 address assignment method for N3000 switches?
The default method is 'none' on VLAN 1.
What is the default configuration for IPv6 on routing interfaces?
DHCPv6 is disabled by default on routing interfaces.
When is the ipv6 enable command valid for the out-of-band interface?
It is only valid for switches equipped with an out-of-band interface.
What is the default power inline priority level?
The default priority level is Low.
What is the default power usage threshold?
The default threshold is 90% of total available power.
