Wilier NDR38 KC Wheels Use and Maintenance Manual

Wilier NDR38 KC wheels use and maintenance manual: hub servicing, spoke replacement, tire pressure limits, brake pad warnings and rider weight limits.


Wilier NDR38 KC Wheels Use and Maintenance Manual - cover page
Brand
Wilier
Category
Bicycle
Document type
User Manual
Language
Italian
Pages
20
File format
PDF
File size
1.2 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2ED3926B9C50D5AD323BE3BD72D45310

About this manual

This is the Italian use and maintenance manual for the Wilier NDR38 KC rim wheels, part of the Wheels Series. It opens with the package contents (front and rear wheel, manual, flap set, Vibrostop, wheel bags and official warranty conditions) and general warnings: use only original spare parts from Wilier Triestina spa, use only Miche brake pads, keep the braking surface clean, and never fit pads that were previously used on aluminum rims to carbon rims. It also covers pre-ride checks, correct tire pressure, spoke tension, wheel retention in the frame and cleaning without high-pressure water.

The maintenance part describes front hub and rear hub servicing with 5 mm hex keys, bearing replacement, freewheel body cleaning and re-greasing of the toothed stator, and hub play adjustment with the ring (D) and grub screw (E) using a 2 mm hex key. It gives the tightening torque for the end caps, the spoke lengths needed for repairs, and step-by-step spoke replacement. The manual is published in Italian, English, French, German and Spanish versions. This manual is written in Italian.

What's inside

  • Package contents
  • General warnings
  • Brake pad and braking surface warnings
  • Pre-ride use warnings and tire pressure
  • Front hub maintenance
  • Rear hub maintenance
  • Spoke lengths
  • Spoke replacement
  • Warranty conditions

Specifications

Maximum tire pressure8 bar / 116 psi
Hub end cap closing torque15 Nm
Rear wheel spoke length (right and left side)277 mm
Front wheel spoke length (right and left side)276 mm
Rider weight limitRiders over 102 kg are advised not to use these wheels
Inspection interval for riders over 85 kgEvery 2 months or 1,500 km
Required hex keys5 mm for hub end caps, 2 mm for the grub screw
Brake padsMiche brake pads only

Frequently asked questions

What tire pressure can I use on the Wilier NDR38 KC wheels?

The pressure indicated at the valve hole is 8 bar or 116 psi, and inflation must never exceed the lower of the tire manufacturer's maximum pressure and the rim manufacturer's recommendation.

Which brake pads should be used with these wheels?

Only Miche brake pads may be used, and the braking surface must be kept clean. Pads previously used on aluminum rims must not be used on carbon rims.

What spoke lengths are needed for repairs?

Front wheel spokes are 276 mm and rear wheel spokes are 277 mm, on both the right and left sides.

With what torque are the hub end caps tightened?

The movable end cap is locked with a closing torque of 15 Nm.

Download PDF (1.2 MB)