WEXS WEXS-10 BLE Sensor User Manual

User manual for the WEXS-10 BLE sensor app covering Android permissions, scanning and connecting sensors, saving CSV data, response time, graphs and…


WEXS WEXS-10 BLE Sensor User Manual - cover page
Brand
WEXS
Category
sensor
Document type
User Manual
Language
English
Pages
9
File format
PDF
File size
705 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
9C7C162AAB571B1072589A92D3493D66

About this manual

This manual explains how to use the WEXS BLE app with the WEXS-10 sensor, which monitors up to 10 sensors, and is compatible with all Phoenix Sensors BLE products (WEPS04, WEPS14, WEPS37, WEHS02, WETS02). It covers pre-requirements for Android devices, including enabling Location and Storage permissions in the app settings.

The manual walks through scanning and connecting to sensors by MAC ID, disconnecting and saving recorded data as a CSV file, changing the sensor's displayed name and response time (up to a maximum of 10000 mS), reading graphical data on the chart screen, and troubleshooting connection problems. Saved data is stored on Android under My Files > Internal Storage, or on Apple devices under Files > On My iPhone > WEXS.

What's inside

  • Pre-Requirements (Android Only)
  • Scanning and Connecting to Sensors
  • Disconnecting and Saving Data
  • Changing Response Time
  • Changing the Sensor's Displayed Name
  • Reading Graphical Data
  • Troubleshooting

Specifications

Sensors monitored (WEXS app)Up to 4 sensors
Maximum response time10000 mS
Bluetooth requirementBLE 4.2 or above
Data file formatCSV
Compatible sensorsWEPS04, WEPS14, WEPS37, WEHS02, WETS02

Frequently asked questions

How do I save data from the WEXS-10 sensor?

Press the save button above the displayed data, then press save on the pop-up showing the .csv data file. All data recorded up to that point will be saved.

Where is the saved data stored?

On Android, data is saved under My Files > Internal Storage in a CSV file; on Apple devices it is saved under Files > On My iPhone > WEXS as a CSV file.

How do I change the sensor's displayed name?

Press the box showing the current display name on the setup screen, enter the new name, then disconnect from the sensor, close the app, remove the sensor's battery for 5 seconds, reinsert it, and reconnect.

Why won't the sensor connect to the app?

Check that location and storage permissions are enabled, Bluetooth is turned on, the sensor's battery still holds power, device storage is not full, and that your phone or tablet supports BLE 4.2 or above.

Download PDF (705 KB)