Warwick Profet 3.3/5.2 Bass Amplifier Owner Manual

Owner manual for Warwick Profet 3.3 and Profet 5.2 bass amplifiers, covering safety notes, operation, protection circuits, technical data and speaker setups.


Warwick Profet 3.3/5.2 Bass Amplifier Owner Manual - cover page
Brand
Warwick
Category
audio amplifier
Document type
User Manual
Language
German
Pages
12
File format
PDF
File size
2.9 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
210F2A216211293F04CA6D8459E5CF03

About this manual

This is the owner manual for the Warwick Profet 3.3 and Profet 5.2 bass amplifiers. The extracted pages are mostly in German and cover safety warnings, general handling notes, the built-in protection circuits and a step-by-step startup procedure, followed by descriptions of the front-panel and rear-panel controls of both models, including gain, compressor, contour, bass/low-mid/high-mid/treble controls, deep and bright switches, master, mute, phones, tuner out, line out, effects loop, DI pre/post and speaker outputs.

An English technical data section lists the specifications of both models, such as 300 W/4 ohms for the Profet 3.3 and 500 W/4 ohms for the Profet 5.2, THD below 0.1%, weights of 8.5 kg and 10.0 kg and 19" rack dimensions. A speaker connection diagram notes the 4-ohm minimum load of the power amplifier and shows example setups with Warwick WCA 211 Pro and WCA 115 Pro cabinets. The manual also carries the WEEE disposal number DE93670540 and is marked CB Approved. This manual is written in German.

What's inside

  • Safety Instructions
  • General Notes
  • Protection Circuits
  • Startup
  • Front Controls
  • Rear Panel
  • Technical Data
  • Speaker Connection Diagram

Specifications

Input sensitivity25 mV
Power output300 W @ 4 ohms (Profet 3.3) / 500 W @ 4 ohms (Profet 5.2)
Weight8.5 kg (Profet 3.3) / 10.0 kg (Profet 5.2)
Dimensions19" / 483 x 90 x 350 mm (W x H x D)
Headphone output200 ohms minimum
Direct Out0 dB, 600 ohms
Bass control±12 dB @ 80 Hz
Power amp coolingFan cooled (non-permanent)
Minimum speaker load4 ohms

Frequently asked questions

What is the minimum speaker load for the Warwick Profet 3.3/5.2?

The minimum load of the power amplifier is 4 ohms. The connection diagram lists matching 4, 8 and 16 ohm cabinet combinations.

How do I know a protection circuit has tripped on my Profet amplifier?

The MUTE LED stays permanently lit even though the amplifier was not switched to mute. After a short circuit, switch the amp off and on again; in other cases it returns to operation automatically once the fault is gone.

What speaker cable cross-section does the manual recommend?

The cables connecting the speakers should have a cross-section of at least 2 x 1.5 mm.

What headphones can be connected to the Profet's PHONES jack?

Headphones with a minimum impedance of 200 ohms.

Download PDF (2.9 MB)

More Warwick Manuals


View all Warwick manuals →