VERSAMATIC VM Air Lubricator Service & Operating Manual

Service and operating manual for VERSAMATIC VM air lubricators, covering installation, lubrication, adjustment, maintenance, cleaning, and limits.


VERSAMATIC VM Air Lubricator Service & Operating Manual - cover page
Brand
Versa-Matic
Category
Other
Document type
Service Manual
Language
English
Pages
4
File format
PDF
File size
360 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
539AE88E373E5EFB72F37CACCEB53ED8

About this manual

The VERSAMATIC VM Air Lubricators service and operating manual provides original instructions for installing, operating, and servicing the lubricator. It covers installation, application limits, lubricant selection, filling, adjustment, maintenance, cleaning, and operating limits for units with polyurethane or zinc bowls.

The document lists accessory part numbers for 1/4-inch, 1/2-inch, 3/4-inch, and 1-inch units and includes warnings about compressed air, electrical supply, chemical compatibility, and cleaning. It also gives maximum operating pressures and temperature ranges for polyurethane-bowl and zinc-bowl units.

What's inside

  • Introduction
  • Application Limits
  • Installation
  • Lubricant
  • Filling
  • Adjustment
  • Maintenance
  • Cleaning
  • Operation Limits
  • Contact Information

Specifications

Maximum operating pressure, polyurethane bowl (1/4, 1/2, 3/4 units)1034 kPa (150 psig, 10 bar)
Operating temperature range, polyurethane bowl4.4°C to 48.9°C (40°F to 120°F)
Maximum operating pressure, zinc bowl (1-inch units)1723 kPa (250 psig, 17 bar)
Operating temperature range, zinc bowl4.4°C to 65.6°C (40°F to 150°F)
Recommended lubricantHigh quality SAE #10 oil (S.U.V. 150-200 SEC @ 100°F)
Maximum alternative lubricant viscositySAE #40 (S.U.V. 800 SEC @ 100°F)

Frequently asked questions

How should a VERSAMATIC VM air lubricator be installed?

Install it vertically with the bowl facing downward, as close as possible to the equipment being protected and after any filter/regulator. Air must flow in the direction of the arrow on top of the body.

What oil should be used in the lubricator?

For average conditions, the manual recommends high-quality SAE #10 oil; other lubricants may be used if not heavier than SAE #40.

Can the lubricator be filled while the system is under pressure?

Yes. The manual states that lubricators can be filled under pressure and without shutting down equipment.

What indicates that the lubricator needs cleaning?

Cessation of oil dripping through the sight dome, regardless of knob adjustment, indicates that cleaning is necessary.

Download PDF (360 KB)

More Versa-Matic Manuals


View all Versa-Matic manuals →