User manual for the Wave S3Smart Flush Actuator by Thomas Dudley Ltd, covering installation, wiring, activation range setup, and operation.
This manual provides step-by-step instructions for installing and configuring the Wave S3Smart Flush Actuator. It covers mounting options, pneumatic and electrical connections, flush testing, and adjusting fill delay and boost settings. The unit uses motion detection to activate full or partial flushes, with configurable activation detection range (ADR) for different environments.
Operation includes locking the unit, activating flushes by waving a hand, and handling obstructions. Icons indicate status: blue for active, red for obstruction, and inactive when outside range. The manual also includes safety and cleaning instructions.
| Mounting Options | Option 1: Direct wall/panel mounting; Option 2: Frame with tunnel for bridging; Option 3: Frame with tunnel for service aperture |
|---|
Cut a recess into the wall or panelling using the provided fixing template. Install the mounting frame directly to the wall (Option 1), or with a bridging tunnel (Options 2 or 3) depending on your setup.
Initiate scanning by pressing both rear buttons. For automatic setup, place the unit on the frame and vacate the area. For manual setup, stand at the desired range during scanning.
Measure the fill time after several flushes, then rotate the fill delay dial to set a duration between 15 and 120 seconds.
Wave your hand within 4cm of the icon representing the flush type (full or partial). The selected icon turns green to initiate the flush.