Installation manual for the SUN-FLEX Monitorarm III (models 500300 / 500500), covering desk clamp and thru-desk mounting, product specifications and…
This installation manual covers the SUN-FLEX Monitorarm III monitor arm, model numbers 500300 and 500500. It describes two mounting methods - a desk clamp for desk thicknesses of 10~50 mm and a thru-desk installation requiring a hole of at least 8.5 mm and a desk thickness of 50 mm or less - and lists the related product specifications such as monitor size, VESA patterns, lift, tilt, swivel and pivot ranges.
The document then shows the install procedure with the module list (including M8x160, M4x12, M6 and M4 parts), the adjust procedure for setting the arm to the monitor's weight, and the finished installation, with a note to keep an extra 40-50 mm length in the joint. The manual is marked as updated for shipments starting April 15, 2019.
| Desk thickness range (desk clamp) | 10~50 mm |
|---|---|
| Thru-desk hole size | ≥ 8.5 mm |
| Desk thickness range (thru-desk) | ≤ 50 mm |
| Monitor size | 30" |
| VESA | 75*75 / 100*100 |
| Pivot | 360° |
| Packing size | Outside: 490*210*440 mm; Inner: 475*195*140 mm |
| Parts included | M8x160, M4x12, M6, M4 |
The desk clamp installation supports a desk thickness range of 10~50 mm.
The thru-desk hole must be at least 8.5 mm, with a desk thickness of 50 mm or less.
The manual lists 75*75 and 100*100 VESA patterns, for a 30" monitor size.
Adjust according to monitor weight; do not adjust the setting unless the gas arm is horizontal.