SUMTOR DM556-IO Digital Two-Phase Stepper Driver User Manual

User manual for the SUMTOR DM556-IO digital two-phase stepper driver, covering specifications, wiring, DIP switch settings, and auto-tuning.


SUMTOR DM556-IO Digital Two-Phase Stepper Driver User Manual - cover page
Brand
SUMTOR
Category
Motor
Document type
User Manual
Language
Chinese
Pages
7
File format
PDF
File size
909 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
927CD6648B75D86E8B927EDA584770AC

About this manual

The SUMTOR DM556-IO is a digital two-phase stepper motor driver using 32-bit DSP processing with variable-current and variable-frequency control. It supports 4, 6, and 8-wire two-phase step-in motors, automatic parameter tuning at power-up, and overvoltage, undervoltage, and overcurrent protection for small and medium automation equipment and instruments.

The manual covers electrical, environmental, and mechanical specifications, control signal interface circuits and timing, driver interfaces and wiring, status indicator fault codes, and DIP switch configuration for current, speed, static half-current, and parameter self-tuning. This manual is written in Chinese.

What's inside

  • Product Overview
  • Features
  • Application Fields
  • Electrical Specifications
  • Environmental and Mechanical Specifications
  • Mechanical Installation
  • Control Signal Interface Circuits
  • Driver Interfaces and Wiring
  • Status Indicators and Fault Codes
  • Current, Speed, and DIP Switch Settings

Specifications

Output current0.1 to 4.2 A
Input supply voltage24 to 50 VDC, typical 36 VDC
Control signal input current6 to 16 mA
Control signal interface level4.5 to 28 VDC
Insulation resistance100 MΩ
Operating humidity40 to 90%RH
Storage temperature-20°C to 80°C
WeightApproximately 280 g
Cooling methodNatural cooling or forced air cooling
Motor types supported4, 6, and 8-wire two-phase stepper motors
Current setting range0.1 to 5.6 A
Default speed setting range40 to 850 rpm
Pulse signal widthGreater than 1.5 μs
Direction signal lead timeAt least 2 μs before pulse signal
Enable signal lead timeAt least 5 μs before DIR
Overcurrent fault thresholdI peak ≥ 25 A
Overvoltage fault thresholdVDC ≥ 90 V
Undervoltage fault thresholdVDC ≤ 18 V

Frequently asked questions

What power supply voltage does the DM556-IO use?

The input supply voltage range is 24 to 50 VDC, with 36 VDC recommended for operation.

How is the output current set on the DM556-IO?

Output current is set with the SW1, SW2, and SW3 DIP switches, with selectable peak output values from 2.1 A to 5.6 A and a default of 1.0 A.

How does the driver perform automatic parameter tuning?

Move SW4 back and forth once within one second. During tuning, no pulse or direction signals should be applied or changed.

What does the red LED indicate?

The red LED is the fault indicator and flashes on a 3-second cycle when a fault occurs. The number of flashes within 3 seconds identifies the fault type.

Download PDF (909 KB)