Stiebel Eltron Sunwarmth CIR Wall-Mounted Infrared Heater Operation and Installation Manual

Operation and installation manual for Stiebel Eltron Sunwarmth CIR wall-mounted infrared heaters, covering safety, mounting, wiring, and maintenance.


Stiebel Eltron Sunwarmth CIR Wall-Mounted Infrared Heater Operation and Installation Manual - cover page
Brand
STIEBEL ELTRON
Category
Other products
Document type
User Manual
Language
English
Pages
56
File format
PDF
File size
6.2 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
97E0B8024C3B0319D0866636419A8D90

About this manual

This manual covers the Stiebel Eltron Sunwarmth CIR wall-mounted infrared heater models CIR 150-1 I, CIR 150-1 O, CIR 200-2 O, and CIR 400-2 O. It provides important safety instructions, appliance description, operation, cleaning, care, and maintenance information.

The installation section addresses project design, locating and mounting the heater, power supply, heat lamp replacement, clearances, wiring diagrams, dimensions, specifications, spare parts, and warranty.

What's inside

  • Important instructions
  • Safety
  • Register your product
  • Appliance description
  • Operation
  • Cleaning, care and maintenance
  • Installation
  • Appliance handover
  • What to do if ...
  • Specification

Specifications

Clearance from combustiblesAt least 3 ft (1 m) from the front, sides, and rear
Minimum front or below clearance36 in (92 cm)
Extension cord (if used)No. 14 AWG minimum, rated for not less than 1875 watts
Power supply120 V models use a grounded outlet; 240 V models are hard wired
Timer controlAll CIR models must be installed on a timer or timer switch

Frequently asked questions

Which Sunwarmth CIR models can be used outdoors or in wet environments?

Model CIR 150-1 I is for indoor use only. Models CIR 150-1 O, CIR 200-2 O, and CIR 400-2 O may be used outdoors or in wet environments.

What clearance is required around the heater?

Keep combustible materials at least 3 feet (1 m) from the front and at least 3 feet (1 m) from the sides and rear, and do not place anything closer than 36 in (92 cm) in front of or below the heater.

Do all CIR models require a timer?

Yes, all CIR models must be installed on a timer or timer switch.

What extension cord can be used with 120 V models?

If an extension cord is used, it must be No. 14 AWG minimum size and rated for not less than 1875 watts.

Download PDF (6.2 MB)

More STIEBEL ELTRON Manuals


View all STIEBEL ELTRON manuals →