Shimano Hollowgram SL Mountain Internal Bearing Installation Guide

German-language installation guide for Shimano Hollowgram SL Mountain internal bearings, covering installation, removal, inspection, and bearing replacement…


Shimano Hollowgram SL Mountain Internal Bearing Installation Guide - cover page
Brand
Shimano
Category
Vehicle Accessories
Document type
Installation Guide
Language
German
Pages
5
File format
PDF
File size
2.3 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
585975DEE8B3090F58AA592D84AAB284

About this manual

This document provides step-by-step instructions for installing, removing, inspecting, and replacing the internal bearings (Innenlager) used in the Hollowgram SL Mountain bottom bracket system. It details the required tools, lubrication requirements, shim configuration, and safety warnings for proper assembly.

The guide includes procedures for bottom bracket installation (Innenlager einbauen), removal (Innenlager ausbauen), bearing inspection (Lager inspizieren), bearing removal (Lager ausbauen), and bearing installation (Lager einbauen). It specifies the use of high-quality bearing grease, a torque wrench, rubber hammer, and Cannondale-specific tools (KT011, KT010, KT013). The BB30 bottom bracket housing must not be machined. This manual is written in German.

What's inside

  • Innenlager einbauen (Bottom bracket installation)
  • Innenlager ausbauen (Bottom bracket removal)
  • Lager inspizieren (Bearing inspection)
  • Lager ausbauen (Bearing removal)
  • Lager einbauen (Bearing installation)
  • Safety warnings and tool requirements

Specifications

Bottom bracket standardBB30
Shim thickness0.5 mm
Maximum number of shims5

Frequently asked questions

How many shims can be used for the Hollowgram SL Mountain bottom bracket?

Up to five 0.5-mm shims can be used, depending on the compression of the wave washer and the crank arm torque.

What lubrication is specified for the spline interface during installation?

A high-quality bearing grease must be applied to the entire spline surface before assembly.

Can the BB30 bottom bracket housing be machined or faced?

No, the BB30 bottom bracket housing must never be turned or face-milled.

Download PDF (2.3 MB)

More Shimano Manuals


View all Shimano manuals →