Addendum to the Sensaphone 1104/08 BusinessSitter Owner's Manual covering external relay use to activate a sounder, strobe, or X10 device when an alarm occurs.
This document is an addendum to the Sensaphone 1104/08 Owner's Manual. It does not explain setup, configuration, or operation; it instructs the user on external relay functions that turn on devices when an alarm occurs. Devices mentioned include an audible sounder, a strobe light, or an X10 device used with an X10 Powerflash module, which is not included.
The Sensaphone 1104/08 BusinessSitter can monitor and check facility status from a cellular or ordinary telephone. Its rear relay contact is normally open and closes when an alarm is detected, activating the attached device; the relay remains closed during the alarm process and can be reset locally or remotely by telephone. The output can be switched with the keypad or over the telephone, and the relay is rated for low-voltage use only.
| Relay contact type | Normally open |
|---|---|
| Rated load | 2 A at 30 V AC; 2 A at 30 VDC |
| Maximum operating voltage | 30 V AC; 30 VDC |
| Maximum operating current | 2 A |
| Maximum switching capacity | 60 VA; 60 W |
The normally open relay contact closes, activating the device attached to the relay. The relay remains closed throughout the alarm process.
Press STATUS, then press 6.
Call the Sensaphone and press a touch-tone when it answers; then press # 6 to turn the output ON.
It is rated 2 A at 30 V AC and 2 A at 30 VDC.