Seg Pivo Duo/Pivo Quad Automatic Gate Opener Installation and Maintenance Guide

Seg Pivo Duo/Pivo Quad automatic gate opener installation and maintenance guide with safety, mounting, manual release, and control board programming…


Seg Pivo Duo/Pivo Quad Automatic Gate Opener Installation and Maintenance Guide - cover page
Brand
SEG
Category
Automation control Equipment
Document type
Installation Guide
Language
Spanish
Pages
2
File format
PDF
File size
4.6 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2653FE86F3E53C4777FED11FDEAF0CE6

About this manual

This Seg guide covers installation and maintenance recommendations for automatic gate openers, including the Pivo Duo/Pivo Quad motor reducers and the UNIF6BA Dupla Ramp control board. It lists installation tools, safety instructions for technicians and users, and mounting procedures for outward- and inward-opening gates.

The document also describes the manual release system, transmitter and travel programming, pause adjustment, and control board features such as external memory, independent electronic deceleration ramps, and a switched-mode 90 Vac to 240 Vac power supply. This manual is written in Spanish.

What's inside

  • Technician installation recommendations
  • User recommendations
  • Important safety instructions
  • Installing on an outward-opening gate
  • Installing on an inward-opening gate
  • Manual release system
  • UNIF6BA Dupla Ramp control board features
  • Transmitter programming
  • Travel programming
  • Adjustments and connectors

Specifications

Operating temperature-5°C to 55°C
Power supply90 Vac to 240 Vac
Motor rangeSingle-phase motors from 1/4 HP to 1/2 HP
Fuse10 A
Recommended underground cable1.5 mm

Frequently asked questions

What safety device is mandatory for the gate automation installation?

The original SEG photocell is mandatory for the installation of the gate automation.

How is the manual release operated?

Turn the release key 90° clockwise.

How do I program a transmitter?

Press and release the TX key on the control board, press the desired key on the transmitter, then press the TX key again to confirm while the programming LED is blinking.

What power supply does the control board use?

The control board uses a switched-mode power supply from 90 Vac to 240 Vac.

Download PDF (4.6 MB)

More SEG Manuals


View all SEG manuals →