PC321 ZigBee Single/3-Phase Power Clamp Quick Start Guide

Quick start guide for the PC321 ZigBee power clamp: safety notices, technical specifications, single- and three-phase wiring, network joining and mounting.


PC321 ZigBee Single/3-Phase Power Clamp Quick Start Guide - cover page
Category
Monitoring Equipment
Document type
Quick Start Guide
Language
English
Pages
10
File format
PDF
File size
753 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2EE140045AEAA59A8A35FE1CB1B7924A

About this manual

The PC321 is a ZigBee power clamp that monitors electricity usage by connecting a clamp to a power cable. It measures Voltage, Current, Power Factor, Active Power and total energy consumption, and is compatible with single- and three-phase electricity. The guide opens with safety handling notices, then lists technical specifications such as ZigBee 2.4GHz connectivity, 100~240 Vac operating voltage, metering accuracy, dimensions and weight.

The document then describes the parts of the device (LED indicator, antenna port, three CT inputs, AC input cable and clamp), the function button and LED status meanings, and the installation procedure with three-phase and single-phase wiring diagrams. It ends with steps for joining a ZigBee gateway network using the Smartlift APP and for mounting the clamp with its mounting bracket.

What's inside

  • Safety Handling
  • Technical Specifications
  • Welcome
  • Get to know your device
  • Function Button
  • LED indicator
  • Installation
  • Configure Network
  • Mounting

Specifications

Wireless ConnectivityZigBee 2.4GHz IEEE 802.15.4, ZigBee HA1.2
RF Range (outdoor/indoor)100m / 30m
AntennaInternal antenna (default), external antenna (optional)
Operating Voltage100~240 Vac 50/60 Hz
Power consumption< 1W
Calibrated Metering Accuracy≤ 100W within ±2W; >100W within ±2%
Electrical parameters measuredIrms, Vrms, Active Power & Energy, Reactive Power & Energy
Operating environment-20℃ ~ +55℃, humidity ≤ 90% non-condensing
Dimensions86(L) x 86(W) x 37(H) mm
Weight415g

Frequently asked questions

How do I reset the PC321 power clamp?

Press and hold the function button for ten seconds until the LED flashes green three times; the LED then flashes red, meaning the clamp is ready to join a network. Energy data is not cleared by this reset.

How do I clear the stored energy data?

Reset the power clamp twice consecutively, with the interval between the two resets shorter than 10 seconds.

What does a red flashing LED mean?

It means the device did not join the ZigBee network.

What do I need to configure the network?

A ZigBee Gateway and the Smartlift APP installed in a mobile phone. Set the gateway to permit joining and the clamp joins automatically.

Which way should the clamp arrow face?

The arrow on the clamp should face the direction of current flow (P1 → P2). If it faces the reverse direction, the reading meter will display 0.

Download PDF (753 KB)

Also Manuals