Operating instructions and parts manual for Omega hydraulic service jacks models 22201 and 22203, including safety, operation, maintenance, and troubleshooting.
This manual provides operating instructions and parts information for Omega’s hydraulic air/lever actuated service jacks, models 22201 and 22203. It covers safety procedures, preparation, lifting and lowering operations, maintenance, and troubleshooting. The jack is designed to lift, not support, a vehicle, and must be immediately supported by jack stands after lifting. Safety warnings emphasize never using the jack as a stand-alone device and always using rated jack stands. Maintenance includes using only approved hydraulic oil and periodic lubrication and cleaning.
| Capacity | 20 Ton |
|---|---|
| Air Pressure Requirement | 7.8 CFM @ 110 - 175 PSI |
No, NEVER use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle with a pair of appropriately rated jack stands.
A minimum of 7.8 CFM @ 110 - 175 PSI is required for air actuated operation.
Use ONLY good grade hydraulic jack oil. Avoid mixing different types of fluid and Never use brake fluid, turbine oil, transmission fluid, motor oil or glycerin.
With the release valve in the OPEN position and saddle fully lowered, remove the oil filler plug/screw, pump 6 to 8 full strokes, then reinstall the plug/screw.