Nuvair Pro CO2 Carbon Dioxide Analyzer Operation Manual

Nuvair Pro CO2 Carbon Dioxide Analyzer operation manual covering setup, sample flow, alarm and calibration settings, maintenance and specifications.


Nuvair Pro CO2 Carbon Dioxide Analyzer Operation Manual - cover page
Brand
Nuvair
Category
Analyzer
Document type
User Manual
Language
English
Pages
24
File format
PDF
File size
1.1 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
51A1E4F1092502C862187AD70D7D7ABF

About this manual

This operation manual describes the Nuvair Pro CO2 Carbon Dioxide Analyzer, a battery-powered NDIR instrument that measures CO2 in gases in the range of 0 to 2000 ppm. It is designed to verify CO2 concentration in stored gas cylinders and to monitor continuous flow of sample gas from a compressor, and it is used with a flow adapter cap and flexible tubing that deliver sample gas to the sensor.

The manual explains the controls, display, alarm, sensor, battery and flow adapter cap, then walks through testing, sample flow method, programming procedures, alarm setting, full scale value setting, calibration point setting and zero calibration. It also covers threshold alarms, powering off, factory reset, maintenance such as analyzer care, battery and sensor replacement, spares and accessories, troubleshooting, relay output schematics, and an appendix with analyzer specifications and warranty information.

What's inside

  • Introduction
  • System Description
  • Controls
  • Display
  • Alarm
  • Sensor
  • Batteries
  • Flow Adapter Cap
  • Testing
  • Programming Procedures

Specifications

Measuring Range0 to 2000 ppm
Resolution0 – 2500 (50 ppm)
Alarm Set PointCustomer set ppm of CO2
Display Accuracy+/- 5%
Sensor TypeNDIR non-dispersive infrared
Expected Sensor Life, Room Air5 years
PowerLithium battery or optional 110/230 V electric
Battery Life6 hours
Response TimeLess than 50 seconds to 90% of final value
Operating Temperature41 to 104 °F (5 to 40 °C)
Storage Temperature14 to 140 °F (-10 to 60 °C)
Operating PressureNot to exceed 1 atmosphere absolute (0 P.S.I.)
Humidity15-90% continuous, 0-99% intermittent

Frequently asked questions

How do I switch the Pro CO2 analyzer on and off?

Hold the On/Off button until the display powers up to switch it on, and hold it until the display goes blank to turn it off.

What gas flow rate should be used with the analyzer?

Gas flow should be regulated to 0.5-3 L/min with no pressure on the sensor; for sample flow through a Nuvair 9517.6 flow reducer the incoming pressure should be 75-100 PSI.

When does the audible alarm activate?

The audible alarm activates when the sensor reaches 199 ppm CO2 or a user programmed level, and it will not clear until the CO2 concentration drops below the user programmed level.

How often must analyzer testing be verified?

Analyzer testing must be verified on a weekly basis, or when moisture and/or temperature swings take place.

Download PDF (1.1 MB)

More Nuvair Manuals


View all Nuvair manuals →