The Negele Messtechnik VSG, VSG-P and VSG-PE setpoint transmitters provide 0...10 V or 0/4...20 mA outputs set by a potentiometer.
The Negele Messtechnik VSG, VSG-P and VSG-PE setpoint transmitters are housed in a DIN standard ABS case for snap mounting to EN50022, with IP20 protection and isolated terminals. They provide a 0...10 VDC output or a switchable 0/4...20 mA output with a burden of 500 Ohm or less.
Adjustment is by a built-in precise potentiometer on the VSG or by an external 0,2...100 kOhm potentiometer on the VSG-P and VSG-PE, with zero and gain adjustable. The document also describes the znd-7 and vnt power supply units and the htr-p calibration device for Pt100 temperature sensors, including operating instructions for the htr-p series. This manual is written in German.
| Dimensions | 45 x 75 x 105 mm |
|---|---|
| Type of protection | IP20 |
| Ambient operating temperature | -10...+55 °C |
| AC power supply | 24, 42, 115, 230 VAC, 47...63 Hz, 5 VA |
| Output voltage | 0...10 VDC |
| Accuracy | ±0,2 % of full scale |
| Built-in potentiometer scale (VSG) | 0...100 %, ± 2 % |
| External potentiometer | 0,2...100 kOhm |
| Current output burden | ≤ 500 Ohm |
They provide standard signals of 0...10 V or 0/4...20 mA, depending on the potentiometer settings.
The type of protection is IP20, with isolated terminals.
Trimmer P2 is used to set the output to 20 mA or 10 V, respectively.
Yes, by remote operating with an external potentiometer.