Installation instructions for the MS Sedco AccuGuard HP2 active infrared 2-beam safety system, including mounting, wiring, setup, and system inspection.
This guide provides step-by-step instructions for installing the AccuGuard HP2 modular safety beam system, including mounting the control module and beam heads, wiring connections, and system setup. It also covers system inspection, compliance with ANSI/BHMA standards, and warranty information. The system is designed for fail-safe operation when beams are interrupted or power is lost.
| Detection Method | Active Infrared 950nm |
|---|---|
| Detection Range | 6 to 32 Feet |
| Power Requirements | 12-24V AC or DC (No Polarity Requirements) |
| Light Resistance | Sun—150,000 LUX Artificial—50,000 LUX |
| Power Consumption | Standby 75mA, Active 100mA |
| Relay Contacts | Form C, Rated @ 1 Amp (resistive loads only) |
| Relay Activation Time | 10 ms |
| Relay Hold Time | 500 ms |
| Temperature Range | -4°F to 140°F (-20°C to 60°C) |
The Control Module signals the door to open, providing a failsafe system.
The system requires a power supply of 12-24 V AC or DC.
The active infrared beams have a detection range of 6 to 32 Feet.
The device operates within a temperature range of -4°F to 140°F.