User manual for the MPS-110001 24-bit isolated USB data acquisition card, covering installation, programming, and specifications.
The MPS-110001 is a 24-bit isolated weak signal acquisition card based on the USB bus. It features comprehensive isolation between the signal and communication ends, allowing the connection of signals with high common-mode voltage. The card includes 4 signal input channels with a sampling noise peak-to-peak value of only 2 microvolts, achieving ultra-high resolution. It comes with built-in programmable gain amplifiers of 32x and 64x. This manual is written in Chinese.
| Interface | USB2.0 Full Speed |
|---|---|
| Input Channels | 1 differential or 4 differential (scan) |
| Input Range | ±1V differential |
| Input Impedance | 100M Ohm (PGA = 1) |
| Sampling Rate (Single Channel) | 10sps or 80sps |
| Programmable Gain | 0.5, 1, 32, 64 |
| Noise Peak-to-Peak (PGA=1, 10sps) | 2uV |
| Isolation Voltage | 1000Vrms |
| Operating Temperature | 0 ℃ - 70 ℃ |
The card provides dynamic link libraries supporting VB, VC, C++Builder, Delphi, LabVIEW, and Matlab.
The sampling noise peak-to-peak value is 2 microvolts when PGA is 1 and sampling rate is 10sps.
Yes, it can completely replace previous PCI cards.