Motor Control Shield Motor Driver Expansion Board User Manual

User manual for the Motor Control Shield, an Arduino/NUCLEO expansion board with L293D drivers for four DC motors or two stepper motors.


Motor Control Shield Motor Driver Expansion Board User Manual - cover page
Category
Board
Document type
User Manual
Language
Chinese
Pages
4
File format
PDF
File size
327 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
536DAB35D07B8A3262B54C7320CA2E49

About this manual

The Motor Control Shield is an expansion board for Arduino and NUCLEO boards built around the L293D dual H-bridge driver chip. It can drive four DC motors or two stepper motors at the same time, and the document states that Arduino and STM32 control examples are provided.

The manual covers the product overview and features, the pin configuration that maps the shield's motor signals (M1A–M4B) and enable signals (M1EN–M4EN) to Arduino and NUCLEO pins, and a demonstration section. The DC motor example uses PWM on the enable pins to set the rotation speed, while the stepper example drives a 28BYJ-48 motor through an eight-beat code sequence with notes on start frequency and the gear reduction ratio. This manual is written in Chinese.

What's inside

  • Product Overview
  • Product Features
  • Pin Configuration
  • Experiment Demonstration
  • DC Motor Example
  • Stepper Motor Example

Specifications

Motor driver chipL293D dual H-bridge
Motor outputsFour DC motors or two stepper motors simultaneously
H-bridges4
Output current per H-bridge600 mA, peak 1.2 A
ESD protectionBuilt in
Motor supply configuration5V or adjustable power supply
Adjustable supply motor range1.25V–6.45V DC motors
Control examplesArduino and STM32

Frequently asked questions

How many motors can the Motor Control Shield drive at once?

It can drive four DC motors or two stepper motors at the same time.

Which driver chip does the board use?

It uses the L293D dual H-bridge driver chip, which on its own can drive two DC motors or one stepper motor.

How is DC motor speed controlled?

The enable pins are connected to Arduino pins with PWM capability, so changing the PWM duty cycle changes the motor speed.

What power supply options are available for the motors?

The motor supply can be configured as 5V or as an adjustable supply; with the adjustable supply two 1.25V–6.45V DC motors can be driven.

Download PDF (327 KB)

Also Manuals