Motic BA210 BA310 Digital Configuration Microscope User Manual

Setup and operation guide for Motic BA210 and BA310 Digital Configuration microscopes, covering software installation, image adjustment and calibration.


Motic BA210 BA310 Digital Configuration Microscope User Manual - cover page
Brand
Motic
Category
microscope
Document type
User Manual
Language
English
Pages
5
File format
PDF
File size
689 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2BD9809CA639C381787ABE16FB02446C

About this manual

This short Motic guide explains how to set up and use the digital configuration of the BA210 and BA310 microscopes. It lists the minimum computer system configuration, describes how to install the Motic Images software from the supplied CD, and explains how to connect the microscope head to a computer USB2.0 port and switch the unit on.

The last sections cover image adjustment with the beam splitter, the Camera icon and 4X to 40X focusing, plus calibration using the calibration slide with four black dots and the Calibration Wizard in the Motic Application Program. A note states that calibration must be repeated when the computer screen or screen resolution changes.

What's inside

  • Preparation
  • Minimum System Configuration
  • Installing the Software
  • Operation
  • Image Adjustment
  • Calibration

Specifications

CPUIntel based 1.4GHz or better for PC, or G4 for Mac
Hard disk space1GB available disk space
RAM512MB or more
Display card32MB display memory
Operating systemWindows XP or higher / Mac OSX
Other requirementsNative USB2.0, CD drive

Frequently asked questions

Should the USB2.0 cable be connected before installing the Motic software?

No. The microscope should not be connected to the computer until the Motic software has been installed.

How do I start the live image from the microscope camera?

Pull the beam splitter all the way out until it clicks into place, then click the Camera icon (shortcut Ctrl M) in the software.

How often does the microscope need to be calibrated?

Calibration must be done at least once on at least one objective, with the 10X recommended, and again whenever the computer screen or screen resolution is changed.

What is used to calibrate the microscope?

The calibration slide with four black dots shipped with the microscope, focused on with a 10X objective, together with the Calibration Wizard in the Motic Application Program.

Download PDF (689 KB)

More Motic Manuals


View all Motic manuals →