Moteck LD3 DC Motor Actuator Installation Manual

Installation manual for the Moteck LD3 DC motor actuator, covering load, mounting, duty cycle, wiring and specifications.


Moteck LD3 DC Motor Actuator Installation Manual - cover page
Brand
MOTECK
Category
Electric motor
Document type
Installation Guide
Language
English
Pages
1
File format
PDF
File size
141 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
5B5DD65F194AA793D121ABCA008FA20B

About this manual

The Moteck LD3 Installation Manual covers a 12/24 V DC motor actuator with clevis-to-clevis mounting and aluminum extension and outer tubes. It lists a maximum load of 1000 N, maximum speed of 45 mm/sec, stroke options from 50 to 300 mm, and gear ratios from 5:1 to 40:1.

The manual gives cautions to disconnect the mains plug before setup, use the correct DC voltage, center the load on the operating direction and avoid side load. It explains wiring polarity for extension and retraction, a 25% duty cycle of 2.5 minutes continuous operation followed by 7.5 minutes rest, working temperature of -26 C to 65 C, and IP54/IP65 options.

What's inside

  • Instructions
  • Caution
  • Important
  • Load Side Load
  • Feature Option
  • Note

Specifications

Working temperature-26 C to 65 C
Motor voltage12/24 V DC
Maximum load1000 N
Maximum speed45 mm/sec
Stroke50, 100, 150, 200, 250, 300 mm
Duty cycle25%
Gear ratio5:1, 10:1, 20:1, 30:1, 40:1
ProtectionIP54 / IP65
MountingClevis to Clevis
Tube materialAluminum extension and outer tubes

Frequently asked questions

How do I extend or retract the actuator?

Connect the red wire to the positive electrode and the black wire to negative to extend; reverse the connections to retract.

What is the duty cycle of each motor?

It is 25%: 2.5 minutes of continuous operation followed by 7.5 minutes of rest.

What is the maximum load?

The maximum load is 1000 N.

What should be done before setup?

Disconnect the mains plug before set up.

Download PDF (141 KB)

More MOTECK Manuals


View all MOTECK manuals →