LTC DC682 quick start guide for the octal 16-bit SoftSpan ADC demonstration circuit, covering PC connection, jumper settings, and analog turret connections.
This quick start guide covers LTC demonstration circuit DC682, which features the LTC1859 octal 16-bit SoftSpan ADC. The ADC supports software-programmable input spans of 0 to 5V, 0 to 10V, +/-5V, or +/-10V from a single 5V supply, and its 8-channel multiplexer can be set for single-ended inputs, differential pairs, or a combination, with inputs fault protected to +/-25V.
To operate the board, connect DC682 to a DC590 USB serial controller using the supplied ribbon cable, then connect the controller to a host PC with a standard USB cable and run the evaluation software. Click COLLECT to begin reading the ADC, and change the channel or range by right-clicking the display indicator. Jumpers JP1 and JP2 select the COM pin connection and reference source, while turret posts provide analog inputs, reference, ground, and power connections.
| Input spans | 0 to 5V, 0 to 10V, +/-5V, or +/-10V |
|---|---|
| Supply voltage | Single 5V |
| Channels | 8 |
| Resolution | 16 bit |
| Fault protection | +/-25V |
| Controller interface | DC590 USB serial controller |
Connect DC682 to a DC590 USB serial controller with the supplied ribbon cable, then connect the DC590 to the PC using a standard USB A/B cable.
The LTC1859 can be software programmed for 0 to 5V, 0 to 10V, +/-5V, or +/-10V input spans.
Yes, the inputs are fault protected to +/-25V, and a fault on one channel does not affect readings on other channels.