This LRP Quantum Sport Series speed control user guide covers installation, wiring, motor suppression, set-up, specifications, troubleshooting and warranty.
The LRP Quantum Sport Series is an electronic speed control for radio-controlled models. The guide explains installation, heat-sink fitting, receiver and motor wiring, Schottky diode and capacitor suppression, and warns against reverse polarity and water contact.
It also covers transmitter settings, the push-button set-up procedure, LED function checks, a troubleshooting table, technical specifications for the Sport, Super Sport and Pro Sport versions, and repair and warranty terms.
| Voltage range / number of cells | 4.8-9.6 V / 4-8 |
|---|---|
| Internal resistance | 0.0015 / 0.00098 / 0.00073 |
| Momentary load (1 sec) | 80 A / 115 A / 155 A |
| Brief load (30 sec) | 40 A / 60 A / 80 A |
| Continuous load (5 min) | 30 A / 40 A / 55 A |
| Recommended motor | 14-36 turns / 12-36 turns / over 7 turns |
| Pulse frequency | 2100 Hz / 2300 Hz / 2500 Hz |
| Weight (excl. cables) | 15.0 g |
| Case size (mm) | 25.4x23.1x16 |
Connect the speed control to the motor and note the colour code: yellow is positive and blue is negative.
Disconnect the battery for about 10 seconds and start again from the first step.
It indicates that temperature protection is active.
No. The guide says they must never be used with a forward/reverse speed control; they are for forward/brake units only.