Kingmach JMZX-212HAT Surface-Mount Vibrating Wire Strain Gauge User Manual

Chinese user manual for the Kingmach JMZX-212HAT surface-mount vibrating wire strain gauge: installation, wiring, testing, calculation and troubleshooting.


Kingmach JMZX-212HAT Surface-Mount Vibrating Wire Strain Gauge User Manual - cover page
Brand
金码
Category
sensor
Document type
User Manual
Language
Chinese
Pages
10
File format
PDF
File size
3.5 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2BFEDB52BF3F9EC345E958C87A1655AC

About this manual

The JMZX-212HAT is a surface-mount smart vibrating wire strain gauge made by 长沙金码测控科技股份有限公司 (Kingmach). It is used to measure stress and strain in concrete and steel structures in bridge, building, railway, transportation, hydropower and dam projects. The gauge uses a vibrating wire design with welded anchors, a built-in temperature sensor and a fully sealed stainless steel housing.

This user manual, version V3.0 revised in April 2023, covers product features and technical parameters, the tools and materials needed for installation, three fixing methods (welding to steel, rebar-planting in concrete and adhesive bonding on steel), protective cover mounting, sensor cable connection and waterproofing, system testing and measurement, calculation of strain values, troubleshooting and removal. This manual is written in Chinese.

What's inside

  • 产品特点
  • 技术参数
  • 安装工具及材料
  • 应变计固定(焊接固定、植筋混凝土固定、胶粘钢结构固定)
  • 保护罩安装
  • 传感器接线
  • 线缆防水保护
  • 记录编号与注意事项
  • 系统调试与测量
  • 应变计的计算

Specifications

Strain measurement range±2500με
Strain measurement accuracy0.5% F.S.
Strain resolution0.1με
Measuring gauge length129 mm
Temperature measurement range-40℃ to +120℃
Temperature measurement accuracy±0.5℃
Steel wire linear expansion coefficient12.2με/℃
Water depth resistance150 m

Frequently asked questions

How are the four cores of the sensor cable defined?

Red is ground, yellow is frequency, blue is the digital signal line and green is the 5 V power line.

How is the strain gauge fixed to steel and to concrete?

Welding to the structure is used for steel structures, and drilling with injected adhesive is used for concrete structures; adhesive bonding is only for short-term measurement on steel.

What does the company's comprehensive tester display?

It can directly display physical values, and it can also display the vibrating wire frequency in Hz.

What should the initial strain reading be after installation?

The initial strain value should be within 4000±200 με; if it is outside this range, the M4 screws of the mounting bases are readjusted with an M3 hex wrench.

Download PDF (3.5 MB)