Gurit SP 115 Clear Epoxy Laminating System Datasheet

Gurit SP 115 is a low-viscosity, ultra-clear epoxy laminating system for clear sail and surfboard laminates, with UV filters and a solvent-free formulation.


Gurit SP 115 Clear Epoxy Laminating System Datasheet - cover page
Brand
Gurit
Category
Chemical products
Document type
Datasheet
Language
English
Pages
8
File format
PDF
File size
181 KB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
1C71AFCB020545351390FEAAE7F01701

About this manual

Gurit SP 115 is a low-viscosity, ultra-clear epoxy laminating system for laminates such as those used in sail and surfboards that are to remain unpainted and need a very clear finish. It contains UV filters that give a transparent pale violet/blue color and is intended for glass fiber reinforcements such as RE210D; it is completely solvent- and styrene-free.

The data sheet describes workshop conditions of 18–25°C and low relative humidity below 70%, mixing ratios of 5:2 by volume or 3:1 by weight, and a cure schedule between 15°C and 30°C. It also lists component properties, working properties versus temperature and cured system properties, including viscosity, gel time, pot life, vacuum flow and demold times, Tg and mechanical data.

What's inside

  • Introduction
  • Instructions for Use
  • Workshop Conditions
  • Surface Preparation
  • Mixing and Handling
  • Cure Schedule
  • Overcoating or Over-laminating
  • Flow Coating
  • Working Properties vs. Temperature
  • Cured System Properties

Specifications

Mix ratio by volume5:2
Mix ratio by weight3:1
Mixed density1.115 g/cm³
Shelf life12 months
Colorpale violet
Initial mixed viscosity at 20°C856 cP
Gel time (150 g mix in water at 20°C)1:00 h:min
Pot life (500 g mix in air at 20°C)0:33 h:min
Glass transition temperature (Tg DMTA peak, 28 days at 21°C)64.4 °C
Cured density1.161 g/cm³

Frequently asked questions

What mixing ratio does Gurit SP 115 use?

SP 115 resin is combined with SP 115 hardener at 5:2 by volume, or 3:1 by weight.

What workshop temperature is SP 115 optimized for?

It is optimized for use between 18°C and 25°C (64°F–77°F); lower temperatures thicken the product and higher temperatures reduce working times.

Can SP 115 be used over polystyrene foam?

Yes. The system is completely solvent- and styrene-free, so polystyrene foam blanks can be safely used for the lightest possible boards.

How long should a flow coating cure before polishing?

Leave the flow coating to cure for at least 48 hours at 20–25°C (68–77°F) before finishing or polishing with rubbing compound.

Download PDF (181 KB)

More Gurit Manuals


View all Gurit manuals →