GCP PV 100 is a cold-applied, self-adhesive double-sided pressure-sensitive tape for detailing and repairing GCP waterproofing membrane laps and repairs.
This two-page product data sheet from GCP Applied Technologies describes PV 100 tape, a double-sided pressure-sensitive tape made with high-performance adhesive. It is intended for detail work and repair on PV 100 pre-applied high-polymer self-adhesive waterproofing membrane and other GCP waterproofing membranes, including short-edge laps, T-joints, inside and outside corners, pile heads, pipe penetrations and repairs.
The sheet lists the stated benefits (strong permanent bonding to the membrane, better system integrity with less risk of water migration or leakage, simple application, and wide compatibility with GCP membranes), gives brief installation steps, and covers product supply, storage, health and safety, quality assurance and GCP technical services. The tape must not be left exposed to sunlight for long periods; it is covered by the membrane during installation to block UV exposure. This manual is written in Chinese.
| Thickness (standard) | 0.4 mm |
|---|---|
| Tape size | 80 mm x 20 m |
| Packaging | 16 rolls per carton |
| Storage conditions | Dry, ventilated place; avoid long-term storage above 40 °C; protect from rain |
| Adhesive type | Double-sided pressure-sensitive adhesive |
Clean the granules off the lap or repair area, apply the tape and press it down, then lay the adjacent membrane and roll repeatedly until firmly bonded.
The standard thickness is 0.4 mm, and each roll measures 80 mm x 20 m, packed 16 rolls per carton.
No. The tape must not be directly exposed to sunlight for long periods; the membrane laid over it prevents UV exposure.
Store it in a dry, ventilated place, avoid long-term storage above 40 °C, and protect it from rain.