Garmin GMR 420/620/1220/2520 XHD2 Series radar installation instructions covering safety, mounting, wiring, power connections, and grounding.
The Garmin GMR 420/620/1220/2520 XHD2 Series installation instructions provide important safety information, required tools, installation considerations, and step-by-step procedures for preparing the mounting surface, installing the radar, and attaching the antenna.
The document also covers wiring and connection considerations, connecting power through a voltage converter or directly to the vessel battery, extending the power cable, and grounding the radar. This manual is written in Chinese.
| Voltage converter input voltage | 10 to 32 Vdc |
|---|---|
| Radar power cable fuse rating | 10 A |
| Voltage converter-to-battery fuse rating | 30 A |
| Direct battery connection fuse rating | 15 A |
| Grounding wire gauge | 3.31 mm² (12 AWG) copper |
| Vertical radar beam | 11.5° above and 11.5° below |
| Radar mounting nut torque | 1.5 kgf-m (130 lb-in. [11 lb-ft]) |
| Antenna bolt torque | 0.81 kgf-m (70 lb-in. [6 lb-ft]) |
The listed tools include a No. 2 Phillips screwdriver, a 5 mm hex wrench, a drill with a 15.0 mm (19/32 in.) bit, a 17 mm (21/32 in.) wrench and torque wrench, 3.31 mm² (12 AWG) copper wire, and marine sealant.
Tighten the hex nuts to 1.5 kgf-m (130 lb-in. [11 lb-ft]).
Tighten the hex bolts to 0.81 kgf-m (70 lb-in. [6 lb-ft]).
The voltage converter requires an input voltage of 10 to 32 Vdc.